crwdns2915892:0crwdne2915892:0
Is your tablet dying quickly or not charging at all? Your battery may need to be replaced. Follow this guide and you'll know exactly how to do it!
crwdns2942213:0crwdne2942213:0
-
-
Heat up an iOpener for 30 seconds and place on all four seams of the screen. A heat gun can be used as well.
-
-
-
The glue is now melted, so using the metal spudger shown, pry open all sides of the tablet.
-
When prying open near the home and touch screen buttons, use a suction cup.
-
-
-
-
Remove the ribbon cable using the Metal Spudger.
-
-
-
Remove all seventeen 3 mm screws using a PH000 Phillips screwdriver.
-
-
-
Lift the black frame using the two Metal Spudgers shown.
-
-
-
Once lifted, flip the grey frame over.
-
This component connects to the sim card.
-
-
-
Unclip the orange ribbon cable located above the battery using the Blunt ESD Tweezer.
-
Remove the four black 3mm screws using a PH000 Phillips screwdriver.
-
-
-
Hold the frame and pop the battery off from the other side.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.