crwdns2915892:0crwdne2915892:0
This guide will show you the steps you need to perform to replace the speaker in your device.
crwdns2942213:0crwdne2942213:0
-
-
Slightly apply pressure and move the blue plastic opening tool downwards to pop the metallic rectangular connector from its socket on the mother board.
-
-
-
Slightly apply pressure and move the blue plastic opening tool downwards to pop the gold rectangular connector from its socket on the mother board.
-
-
-
Slightly apply pressure and move the blue plastic opening tool downwards to pop the gold square connector from its socket on the mother board.
-
-
-
Using the spudger gently wedge the blue wire out of its compartment.
-
-
-
-
Remove two 2 mm #000 Phillips screws securing the metallic charger port cover to both the logic board and the front panel.
-
-
-
Squeeze the metal charger port cover piece with the tweezers to gently lift it from it's place.
-
-
-
Carefully insert the flat end of the blue plastic opening tool under the black plastic fastener and lift.
-
-
-
Squeeze the golden cable with the tweezers and gently pull the cable to the left to free the end of the golden cable.
-
-
-
Remove three 2 mm #000 Phillips screws securing the mother board to the front panel.
-
-
-
Using your hands, hold the opposite ends of the mother board corners, and lift.
-
-
-
Insert the opening tool tip into the crack between the speaker and device.
-
-
-
Gently pry up on the speaker to disconnect the speaker from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
The Citadel Military College of South Carolina, Team S1-G2, Eggleston Spring 2020 crwdns2935289:0The Citadel Military College of South Carolina, Team S1-G2, Eggleston Spring 2020crwdne2935289:0
CMCSC-EGGLESTON-S20S1G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
