crwdns2915892:0crwdne2915892:0
Follow this guide to replace the display or screen adhesive for the Samsung Galaxy S7. This guide is used in conjunction with the Galaxy S7 screen replacement guide.
crwdns2942213:0crwdne2942213:0
-
-
Remove all traces of adhesive and debris from the phone's frame. Clean the adhesion surface with high concentration isopropyl alcohol (over 90%) and wipe it clean with a lint-free cloth.
-
Peel off the clear plastic backing from the pre-cut adhesive strip, exposing one side of adhesive.
-
-
-
Carefully line up an edge of the adhesive with the corresponding edge of the phone frame. Make sure the adhesive is properly oriented.
-
Set the adhesive down lightly on the frame.
-
Make sure that the adhesive cutouts match the phone, and that the camera and sensors are not covered by adhesive.
-
If it is not properly aligned, carefully peel the adhesive back up.
-
-
-
-
Once the adhesive is aligned on the frame, run the flat end of a spudger around the perimeter of the adhesive to press it into place. You can also use your fingers.
-
-
-
Continue reassembling your device until you are ready to attach the screen.
-
Peel and remove the green plastic liner from the adhesive strip to expose the screen-facing adhesive.
-
Align and set the phone screen on top of the adhesive.
-
Use your fingers to squeeze around the perimeter of the phone to set the adhesive.
-
Apply a few books worth of weight on top of the screen for an hour to help the adhesive bond.
-
Follow this link to return to the Galaxy S7 screen replacement guide.
Follow this link to return to the Galaxy S7 screen replacement guide.
crwdns2935221:0crwdne2935221:0
crwdns2935229:013crwdne2935229:0
