crwdns2915892:0crwdne2915892:0
This is a prerequisite guide! This guide is part of another procedure and is not meant to be used alone.
Prerequisite guide for fingerprint sensor steps that happen before the motherboard removal, for the Samsung Galaxy S10e.
crwdns2942213:0crwdne2942213:0
-
-
Use the point of a spudger to pry up and disconnect the fingerprint sensor connector from its motherboard socket.
-
-
-
Use a Phillips driver to remove the two 4 mm screws securing the fingerprint sensor bracket.
-
-
-
-
Apply a heated iOpener to the fingerprint sensor bracket for one minute to loosen the adhesive.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use the points of your tweezers to slowly pry up the fingerprint sensor bracket.
-
Remove the fingerprint sensor bracket.
-
-
-
Use a pair of tweezers to loosen the fingerprint sensor cable from the adhesive gasket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
