crwdns2915892:0crwdne2915892:0
Use this guide to replace the headphone jack and earpiece speaker assembly of your Samsung Galaxy Note.
crwdns2942213:0crwdne2942213:0
-
-
Grasp the cap of the stylus and remove it from its slot in the midframe.
-
-
-
Pry with a plastic opening tool, or your fingernail, in the divot to the right of the rear-facing camera, near the volume rocker.
-
-
-
Lift and remove the rear case from the phone.
-
-
-
Insert your finger in the notch of the battery compartment.
-
Press the battery toward the rear facing camera while pulling outward.
-
-
-
Use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeper into its slot until you hear a click.
-
After the click, release the card and it will pop out of its slot.
-
-
-
Remove the microSD card from its slot in the midframe.
-
-
-
Use a plastic opening tool, or your fingernail, to push the SIM card out of its compartment.
-
-
-
-
Slide the SIM card out the rest of the way with your thumb and remove it from the device.
-
-
-
Remove the nine 3.4 mm Phillips #00 screws securing the midframe to the display assembly.
-
-
-
Insert your plastic opening tool to the left of the power button between the midframe and the front panel assembly and pry.
-
-
-
Slide the plastic opening tool down the seam.
-
-
-
Insert your plastic opening tool to the left of the headphone jack between the midframe and the display assembly.
-
Slide the opening tool along the top edge of the phone.
-
Continue to run the plastic opening tool around the perimeter of the phone until the midframe is separated.
-
-
-
Remove the midframe from the display assembly.
-
-
-
Use the flat end of a spudger to disconnect the headphone jack/earpiece speaker assembly cable connector.
-
-
-
Remove the two 3 mm Phillips #00 screws securing the upper display assembly bracket.
-
-
-
Use a pair of tweezers, or your fingers, to remove the upper display assembly bracket.
-
-
-
Use the flat end of a spudger to disconnect the headphone jack/earpiece speaker assembly connector.
-
-
-
Use the point of a spudger to pry the headphone jack out of its recess in the display assembly.
-
-
-
Use a pair of tweezers, or your fingers, to remove the headphone jack/earpiece speaker assembly from the display assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:011crwdne2935229:0
crwdns2917034:0crwdne2917034:0
I'd recommend getting an Original part if possible, the knock off speaker has no metal casing where the original does.
