crwdns2942213:0crwdne2942213:0
crwdns2936621:0crwdne2936621:0
-
-
Heat the back cover to melt the strong adhesive sticker underneath.
-
-
-
Try to pull and open a gap between back cover and frame after heat. Insert into a guitar pick to cut the sticker.
-
-
-
-
If you do it hardly, you need much more heat especially the edged side.
-
Slipping a playing card through the gap is a good way to loosen up the adhesive.
-
-
-
Remove the back cover. The white stripe is the sticker.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:045crwdne2935229:0
crwdns2947412:09crwdne2947412:0
What about putting the one back on?
will it go back on and stay on without new adhesive?
I suggest that you take new adhesive, old adhesive is not strong enough to hold back cover.
Witrigs -
You can check this video of put it back battery cover : https://www.youtube.com/watch?v=3HrmeVGY...
How do I remove the sticky part
