crwdns2915892:0crwdne2915892:0
Home Button and Audio Jack guide for a Samsung Galaxy J3 Emerge Model SM-J327P. May need to replace the home button if it is unresponsive. If audio becomes distorted when plugged in to the jack it needs replacing.
crwdns2942213:0crwdne2942213:0
-
-
Heat up the edges of the screen with a hair dryer.
-
Put the iFixit Opening Tool between the screen and body to open the edge of the screen up.
-
Work the iFixit Opening Tools around the whole screen to break the glue.
-
-
-
Lift the screen up from the bottom.
-
Pry the gray cover open.
-
-
-
Pry the connector off of the motherboard by using a clean nail or the iFixit opening tool.
-
-
-
Remove the eleven Phillips #00 3.5mm screws.
-
-
-
-
Turn the phone over and push down where the battery was.
-
-
-
Insert the iFixit Opening Pick between the motherboard and the panel.
-
Work the iFixit Opening Pick around the outside of the motherboard.
-
-
-
Pry the motherboard away from the phone using your hand.
-
-
-
Slide the home button to the left to pop it off.
-
-
-
Remove the connector where the home button was using the iFixit Opening Pick.
-
-
-
Lift up the connector and push it through the motherboard by following the ribbon.
-
-
-
Follow the ribbon and gently pop the audio port out using the iFixit Opening Pick.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0