crwdns2942213:0crwdne2942213:0
-
-
Use a heat gun or hair dryer to heat up the front edges of the phone for about two minutes. Stay approximately six inches away from the screen to prevent phone damage.
-
-
-
While the screen adhesive is still warm and flexible, insert a pry tool or plastic card between the glass display and the frame of the phone.
-
Slowly slide another pry tool around all the edges of the phone in order to break the adhesive's bond to the display.
-
-
-
-
Gently lift lower side and loosen all edges to hinge screen up from bottom.
-
-
-
Use your prying tool to slowly pry up on the bottom right corner of the white cable guard, exposing a thin ribbon cable connector.
-
-
-
Pry up the ribbon cable connector revealed from under the cable guard and remove the display from the device.
-
Clean the residue from the phone edges before re-assembling phone with new screen.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team S2-G4, Riccardelli Fall 2018 crwdns2935289:0University of North Texas, Team S2-G4, Riccardelli Fall 2018crwdne2935289:0
UNT-RICCARDELLI-F18S2G4
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
