crwdns2915892:0crwdne2915892:0
This guide will enable you to replace the screen in case of broken glass, failure to respond, etc. You will need a heat gun, Phillips #00 screwdriver, iFixit opening tool, and tweezers. Take care when using dangerous tools.
crwdns2942213:0crwdne2942213:0
-
-
Turn the smartphone off by using the power button on the right-hand side.
-
-
-
Turn the smartphone over so that the rear camera is face up.
-
-
-
Use your fingernail or a flat tool to lift the back cover.
-
-
-
Locate the battery near the bottom of the phone. The battery is square, flat, and is labeled 'SAMSUNG'.
-
-
-
Use your fingernail or a flat tool to lift the battery out.
-
-
-
-
Use the Phillips #00 screwdriver to remove the eight 4 mm screws from the midframe.
-
-
-
Use a heat gun or hair dryer to loosen the adhesive between the midframe and the rest of the device.
-
-
-
Use the iFixit Opening Tool to lift the frame.
-
-
-
Use tweezers to disconnect the power ribbon from the motherboard.
-
-
-
Use tweezers or your hand to remove the audiojack.
-
-
-
Use the iFixit Opening Tool to remove the mother board.
-
-
-
Lift the plastic panel that separates the digitizer and the motherboard with an iFixit Opening Tool
-
-
-
Use a heat gun and an iFixit Opening Tool tool to separate the screen from the digitizer.
-
-
-
Use tweezers to disconnect the digitizer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Sam Houston State, Team S11-G2, Blackburne Fall 2018 crwdns2935289:0Sam Houston State, Team S11-G2, Blackburne Fall 2018crwdne2935289:0
SHSU-BLACKBURNE-F18S11G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2917034:0crwdne2917034:0
What if the phone does not come back on after assembly
