crwdns2942213:0crwdne2942213:0
-
-
Begin by turn the device over to it's back, with the screen facing down.
-
-
-
At the top of the device there is a small notch that is used to remove the battery door.
-
Using a pry tool or your fingernail, pry off the battery door from the main housing.
-
-
-
Place the battery door to the side.
-
Using a pry tool or your fingernail, pry the battery up towards you.
-
You have now removed the battery!
-
-
-
Remove the 6 Phillips head screws that hold the rear housing in place.
-
-
-
-
Using a spudger or plastic pry tool, slowly go around the phone between the display & rear housing to release the clips.
-
-
-
Lift the rear housing from the display assembly.
-
-
-
Using your spudger/plastic pry tool, disconnect the headphone jack flex cable.
-
-
-
Using your spudger/plastic pry tool, disconnect the rear speaker flex cable.
-
-
-
Using a spudger/pry tool, carefully remove the vibration motor from its housing. This has a mild adhesive on the bottom.
-
-
-
After removing both flex cables, slowly move the logic board to the left of the screen assembly.
-
-
-
Using your spudger/plastic pry tool, disconnect the LCD/Digitizer flex cable.
-
-
-
You have now removed the logic board from the display assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0