crwdns2915892:0crwdne2915892:0
This guide gives instructions not only for removing a broken charging port but also for replacing it with a brand-new one. This will be helpful mainly when a device is not charging properly or if there is any damage to the charging port itself. This guide is tedious and requires skills with a soldering iron.
Special Skills
- Heat gun usage
- Soldering iron usage
crwdns2942213:0crwdne2942213:0
-
-
Remove the SIM card and the SIM card tray.
-
Use an iOpener or heat gun to warm the adhesive that secures the back cover.
-
Insert an opening pick in the seam between the back cover and chassis while the adhesive is warm.
-
Slide the pick around the entire perimeter.
-
Remove the back cover.
-
-
-
Remove all thirteen 3.6 mm Phillips screws that secure the midframe.
-
Use an opening pick to pry up and lift out the midframe.
-
-
-
-
Use an opening tool to gently pry up the press connectors on both ends of the two ribbon cables.
-
Use an opening tool to gently pry up the press connectors on both ends of the two ribbon cables.
-
-
-
Disconnect the red antenna cable from the I/O board.
-
Use an opening pick to pry up and remove the I/O board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
University of North Texas, Team 2-2, Kilpatrick Spring 2024 crwdns2935289:0University of North Texas, Team 2-2, Kilpatrick Spring 2024crwdne2935289:0
UNT-KILPATRICK-S24S2G2
crwdns2931471:05crwdne2931471:0
crwdns2935297:05crwdne2935297:0
