crwdns2915892:0crwdne2915892:0
You will need to find a clean area to work in and have the necessary tools. Follow this guide to gain access to your cellphone's digitizer and screen.
crwdns2942213:0crwdne2942213:0
-
-
Remove the back battery cover.
-
-
-
Using a nylon spudger, remove the phone's battery.
-
-
-
Remove six (4.28 x 1.25)mm screws using the Phillips #00 screwdriver.
-
-
-
Use a nylon spudger to gently pry the silver plastic back plate from the body of the phone.
-
-
-
Pull the antenna plug out of its socket.
-
-
-
-
Pop the two black hinged-release levers toward their ribbons, then slide the ribbons out.
-
-
-
Pop the red hinged-release lever away from its ribbon. Then pull it out.
-
-
-
Peel the button sensor on the side of the motherboard off of the case.
-
-
-
Slightly pull up one side of the motherboard.
-
Pull the button/microphone plug out of its socket.
-
Pop the red hinged-release lever away from its ribbon, then slide the ribbon out.
-
-
-
You have successfully removed the motherboard from the phone.
-
-
-
Flip the phone over so you are looking at the front screen of the phone.
-
-
-
Use a small tool to pry the digitizer and screen (together) from the frame of the phone.
-
-
-
Next, carefully pull the digitizer away from the screen.
-
At this point you can replace either the screen or the digitizer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 15-11, Regan Spring 2011 crwdns2935289:0Cal Poly, Team 15-11, Regan Spring 2011crwdne2935289:0
CPSU-REGAN-S11S15G11
crwdns2931471:05crwdne2931471:0
crwdns2935297:014crwdne2935297:0
crwdns2947412:03crwdne2947412:0
You did not mention how to glue the digitizer to LCD. That is a very important step.
Do these steps also work for the Samsung Eternity 2?
Está mierda no sale
