crwdns2915892:0crwdne2915892:0
This guide is a step-by-step guide on how to replace the Samsung Chromebook 3 XE500C13-K02US Touchpad. You will need to remove the battery, remove the I/O board, remove the speakers, remove two port covers, then disconnect the display from the keyboard and remove the touchpad.
crwdns2942213:0crwdne2942213:0
-
-
Place the laptop back cover facing up to expose all nine 4.6 mm screws.
-
Remove all nine 4.6 mm screws using a Phillips #00 screwdriver.
-
-
-
Wedge a plastic opening tool underneath the cover of the laptop.
-
Once the tool is wedged between the cover and the body of the laptop, slide the tool around the edge of the laptop to disengage the retaining clips.
-
Remove the cover of the laptop to expose the inside components.
-
-
-
Remove the four 4.6 mm screws with the Phillips #00 screwdriver.
-
-
-
Use the spudger to pry underneath the cable and remove the connector.
-
Remove the battery from the case.
-
-
-
Use the Phillips #00 screwdriver to remove the three 4.6 mm screws from the silver bracket.
-
Remove the silver bracket.
-
Remove the remaining 4.6 mm screw from the I/O board.
-
-
-
Remove the wire connector from the I/O board.
-
Remove the black and white wires from the I/O board.
-
-
-
-
Lift the clip of the ribbon cable connector.
-
Remove the ribbon cable from the I/O board.
-
-
-
Lift and remove the I/O board from the base of the laptop.
-
-
-
Use the Phillips #00 screwdriver to remove the three 4.6 mm screws from the silver port.
-
-
-
Remove the silver port from the motherboard.
-
-
-
Remove the red and black speaker wires from the connector on the motherboard.
-
Use the #00 Phillips screwdriver to remove the 4.9 mm screw.
-
Repeat the first two steps for the other speaker.
-
-
-
Remove the smaller cable ribbon from the port on the motherboard.
-
Lift the clip on the connector on the motherboard and remove the larger cable ribbon.
-
-
-
Use the #00 Phillips screwdriver to remove the four 4.6 mm screws.
-
-
-
Lift and remove the motherboard from the base of the laptop.
-
-
-
Use the #00 Phillips screwdriver to remove the two 4.6 mm screws from both display hinges.
-
Lift the display hinges and remove the keyboard from the screen of the laptop.
-
-
-
Use the #00 Phillips screwdriver to remove the three 2.3 mm screws from the trackpad.
-
-
-
Remove the grey adhesive tape and lift out the trackpad to remove it from the keyboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team 3-3, Harley Spring 2023 crwdns2935289:0IUPUI, Team 3-3, Harley Spring 2023crwdne2935289:0
IUPUI-HARLEY-S23S3G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:03crwdne2935297:0
