crwdns2915892:0crwdne2915892:0
This guide is intended for the removal/replacement of the hinges in a Samsung Chromebook 3 XE500C13-K02US. It could also serve as guide for similar models. To do so, the bottom case has to be removed, then the wires running from the hinges to I/O board are disconnected. Afterwards, there are a couple of screws that are removed, then the nuts and washers holding the hinge.
crwdns2942213:0crwdne2942213:0
-
-
Place the laptop back cover facing up to expose all nine 4.6 mm screws.
-
Remove all nine 4.6 mm screws using a Phillips #00 screwdriver.
-
-
-
Wedge a plastic opening tool underneath the cover of the laptop.
-
Once the tool is wedged between the cover and the body of the laptop, slide the tool around the edge of the laptop to disengage the retaining clips.
-
Remove the cover of the laptop to expose the inside components.
-
-
-
-
Disconnect black and white wire from the I/O board.
-
Remove two 4.6 mm screws from the display hinge using a Phillips #00 screwdriver.
-
Rotate both display hinges upward, away from the components.
-
-
-
Remove the nuts with a 5 mm nut driver socket.
-
Remove all six washers from each side.
-
-
-
Remove the hinges from the bar on both sides.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
IUPUI, Team 3-3, Harley Spring 2023 crwdns2935289:0IUPUI, Team 3-3, Harley Spring 2023crwdne2935289:0
IUPUI-HARLEY-S23S3G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:03crwdne2935297:0
