crwdns2915892:0crwdne2915892:0
If your air conditioner is not changing temperature or you can not turn it on, there is a great chance that the problem lies in the circuit board. Over time, the circuit board can be damaged due to different reasons. Without the circuit board, the unit is almost unusable.
Use this guide to replace the circuit board in your Samsung ASV09PSBAN air conditioner or similar air conditioner if applicable
Before starting this guide, make sure to turn the power off in the room where the unit is connected. Turn off the circuit breaker that provides power for the unit. Without turning the power off, you may accidentally harm yourself or the unit.
crwdns2942213:0crwdne2942213:0
-
-
Turn off the power from the circuit breaker.
-
-
-
Carefully remove the front grille panel by placing your hands at the top of the air intake cover.
-
-
-
Use your hands to remove the air filters.
-
-
-
Remove the screw from the small panel on the right side.
-
Remove the cover.
-
-
-
Disconnect the black wire from the unit.
-
-
-
-
Disconnect the two parts of the white wire.
-
-
-
Remove two screws from each side of the front panel.
-
-
-
Remove the old circuit board from the three notches holding it in place.
-
Thread the bundled white wire through the slot and remove the circuit board completely from the unit.
-
Install a new circuit board.
-
-
-
Reinstall the front panel.
-
Replace the two screws on each side of the front panel.
-
-
-
Reconnect the white wires.
-
Thread the black wire through the slots.
-
-
-
Restore the power to check if the unit is functioning.
-
-
-
If the unit is functioning, turn the fan off, and reinstall the front grille panel.
-
At the end, you can turn it on again.
-
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
UMass Dartmouth, Team S1-G12, Sinclaire Spring 2021 crwdns2935289:0UMass Dartmouth, Team S1-G12, Sinclaire Spring 2021crwdne2935289:0
UMASSD-SINCLAIRE-S21S1G12
crwdns2934841:01crwdne2934841:0
crwdns2935303:01crwdne2935303:0
crwdns2917034:0crwdne2917034:0
I am having problem like different way, if I set temperature from 23'C to 17'C than only outdoor unit (compressor unit) start working. Even though it's started, but I feel the temperature like 29 'C only. What will be the problem? Suggest me..
