crwdns2915892:0crwdne2915892:0
Subwoofers are notorious for blowing out. Consistent use at low frequencies result in a short life span for these parts.
This guide will show you how to replace the subwoofer instead of having to throw out you entire device. A replacement subwoofer can be found online or salvaged from another device.
crwdns2942213:0crwdne2942213:0
-
-
Lift up the handle to reveal the screws.
-
Use your Phillips #2 screwdriver to remove the eight 1/2 inch screws.
-
-
-
Flip your device over.
-
Use your Phillips #2 screwdriver to remove the six 3/4inch screws.
-
-
-
Flip your device back over to access the top of the device.
-
Use your plastic opening tool to pry up and remove the panel on the top, left hand side of the device.
-
-
-
Use your Phillips #2 screwdriver to remove the two 1/2 inch screws underneath the now-removed panels.
How do you remove the carrying handle
Seems the handle has to come off before the top….. how does the handle get removed? Thanks!
Well this is stupid. You don’t show the handle being removed. I bet you broke it. You people don’t know what you are doing.
-
-
-
Lift off the top, beginning from the back of the device.
-
-
-
-
Disconnect the CD drive ribbon cable from the top of the device.
-
-
-
Disconnect the remaining cables from the motherboard.
-
-
-
Once you have removed the top, we will begin removing the front of the device.
-
Begin by disconnecting the 6 cables that lead from the front of the device to the motherboard.
-
-
-
Use your Philips #2 screwdriver to remove the two 1 inch screws on the outermost part of the device.
-
Use your Philips #2 screwdriver to remove the two 3/4 inch screws on the outermost part of the device.
-
Use your Philips #2 screwdriver to remove the one 5/6 inch screw on the middle part of the device.
-
-
-
Firmly pull off the front of device.
-
-
-
Begin with the front component after the disassembly prerequisite.
-
This guide is for the subwoofer seen in the middle of this image.
-
-
-
Desolder the two connector wires off the bottom plate on the speaker.
-
Note where each cable connects.
-
-
-
Remove the four 1/2 inch screws using a #2 Phillips screwdriver.
-
-
-
Firmly grab the end of the subwoofer.
-
Pull up and out to remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2947410:01crwdne2947410:0
You completely forgot about the screws in the CD Drive. Nearly broke the top plastic prying on it.
