crwdns2915892:0crwdne2915892:0
This guide will be showing step-by-step instructions on how to get to and replace the spring of the airsoft gun.
crwdns2942213:0crwdne2942213:0
-
-
Using a flathead screwdriver, remove the pin holding the hand guard in place.
-
Remove the hand guard.
-
-
-
Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun.
-
-
-
Turn the gun over so that you are facing the bottom of the gun.
-
Using a Phillips #1 screwdriver, remove the following screws:
-
Remove the 8mm screw that is located directly underneath the cocking lever.
-
Remove the 8mm screw located beside the screw you just removed.
-
-
-
Carefully tug on the tip of the gun and pull the barrel and its cover out.
-
-
-
Locate the hand grip.
-
Using a Phillips #0 screwdriver, remove the two 6mm screws at the bottom of the hand grip.
-
Slide the cover off.
-
-
-
Pull the motor out of the hand grip.
-
Using a Phillips #1 screwdriver, remove the two 5mm screws inside of the hand grip.
-
-
-
-
Locate the pin holding the folding stock in place.
-
Using an allen wrench or something small, carefully push the pin out.
-
-
-
Using a Phillips #1 screwdriver, remove the 20mm screw behind the folding stock and above the gearbox.
-
Remove the cover that was held on by the screw.
-
-
-
Using a flathead screwdriver, remove the two 5mm screws beside the safety switch on both sides of the gun.
-
Slide off the piece that was held on by those screws.
-
-
-
Using a small allen wrench, carefully unscrew the screws holding the safety switch in place on both sides of the gun.
-
-
-
Using a Phillips #0 screwdriver, remove the two 6mm screws that were underneath the safety switch on both sides of the gun.
-
Carefully remove the pieces that were held on by the screws.
-
-
-
Pull apart the cover when pulling the gearbox out.
-
Pull the gearbox out.
-
-
-
Using a Phillips #1 screwdriver, remove the following screws:
-
Remove these four 15mm screws.
-
Remove this single 8mm screw.
-
Using a Phillips #0 screwdriver, remove the following screws:
-
Remove this single 3mm screw.
-
Remove this single 14mm screw.
-
Detach the pieces unscrewed from the gearbox.
-
-
-
Remove the piece covering the trigger.
-
Remove the safety piece.
-
Using a Phillips #1 screwdriver, remove the 18mm screw beside the trigger.
-
-
-
Remove the cover and pull out the spring.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 18-41, Regan Fall 2012 crwdns2935289:0Cal Poly, Team 18-41, Regan Fall 2012crwdne2935289:0
CPSU-REGAN-F12S18G41
crwdns2931471:06crwdne2931471:0
crwdns2935297:06crwdne2935297:0
crwdns2917034:0crwdne2917034:0
When i read step 15 it seems impossible to up/downgrade spring without damaging the gun permanently??
