crwdns2931653:01crwdne2931653:0 Trigger



• Lay the device on its side.
• Remove eight 5 mm screws using a TR10 Torx screwdriver.
• Separate the two halves by pulling up on the top half.
• The two halves are still attached, so use caution when opening the device.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:02crwdne2931653:0

• Use a Phillips head screwdriver to remove this bracket.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:03crwdne2931653:0
• Locate the red and black wires connecting the trigger to the motor.
• Use a soldering iron to separate these wires from the trigger.
• For soldering help, visit the How to Solder and Desolder Connections guide.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

<iframe id="dozuki-embed-161000" src="https://ts.ifixit.com/Guide/embed/161000/full" width="800" allowfullscreen frameborder="0"></iframe> <script>window.addEventListener("message",function(a){var b=document.getElementById("dozuki-embed-161000"),c=a.data[0],d=a.data[1];switch(c){case"setHeight":b.style.height=d+"px"}},!1);</script> <iframe src="https://ts.ifixit.com/Guide/embed/161000" width="800" height="584" allowfullscreen frameborder="0"></iframe>

crwdns2852917:0crwdne2852917:0