crwdns2915892:0crwdne2915892:0
This guide is for the removal or installation of the rotary multi selector wheel.
crwdns2942213:0crwdne2942213:0
- 
   
   - 
                     
            Unscrew the two 3.5mm Phillips screws from the side with the AV outlet. 
- 
                     
            Unscrew the 3.5mm Phillips screw from the opposite side of the camera. 
- 
                     
            Unscrew the six 3.5mm Phillips screws from the bottom of the camera. 
 
- 
                     
            
- 
   
   - 
                     
            Carefully remove the back casing from the camera. 
 
- 
                     
            
- 
                     
                                                
- 
   
   crwdns2935267:0crwdne2935267:0Tweezers$4.99- 
                     
            Place the plastic opening tool underneath the ribbon tab as shown. Gently lift the tab up. 
- 
                     
            Gently pull the ribbon from the logic board with tweezers. 
- 
                     
            With the ribbon disconnected, the back casing should now be detached from the rest of the camera. 
 
- 
                     
            
- 
   
   crwdns2935267:0crwdne2935267:0Tweezers$4.99- 
                     
            Lift up the metal cover and its button slowly using the tweezers. 
 
- 
                     
            
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
