crwdns2942213:0crwdne2942213:0
-
-
Heat up the iOpener for 30 seconds in the microwave and place across rubber pads on the back of the device.
-
-
-
Gently use the plastic opening tool to pry the rubber pads off.
-
-
-
Remove the four Phillips #000 screws from the bottom of the case.
-
-
-
-
Gently remove the under side of the device.
-
-
-
Remove the middle component that is held in place by the top and bottom of the device.
-
-
-
Remove the cover over the A/V ports on the front of the device.
-
-
-
Remove the board from the plastic enclosure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.