crwdns2915892:0crwdne2915892:0
Replace the case of the device.
crwdns2942213:0crwdne2942213:0
-
-
Heat up the iOpener for 30 seconds in the microwave and place across rubber pads on the back of the device.
-
Note: It may take several heats, left for a minute at a time, to loosen the glue.
-
-
-
Gently use the plastic opening tool to pry the rubber pads off.
-
-
-
Use the 000 phillips to remove the screws found under all four of the rubber pads.
-
-
-
-
Gently remove the under side of the device.
-
-
-
Remove the middle component that is held in place by the top and bottom of the device.
-
-
-
Remove the cover over the A/V ports on the front of the device.
-
-
-
Remove the board from the plastic enclosure and put the board into the replacement enclosure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2947410:01crwdne2947410:0
cause mine get’s hot and it’s slow as !&&*