Roku 2 Case Replacement
crwdns2944109:0crwdnd2944109:0Eric Rawlscrwdnd2944109:0crwdnd2944109:0crwdnd2944109:0crwdne2944109:0
crwdns2944111:0N'w 8, 2015crwdne2944111:0
crwdns2915892:0crwdne2915892:0
crwdns2942287:0crwdne2942287:0Replace the case of the device.
crwdns2942213:0crwdne2942213:0
crwdns2943215:0crwdne2943215:0
crwdns2944105:0crwdne2944105:0
-
-
Heat up the iOpener for 30 seconds in the microwave and place across rubber pads on the back of the device.
-
Note: It may take several heats, left for a minute at a time, to loosen the glue.
-
-
-
Gently use the plastic opening tool to pry the rubber pads off.
-
-
-
Use the 000 phillips to remove the screws found under all four of the rubber pads.
-
-
-
Gently remove the under side of the device.
-
-
-
Remove the middle component that is held in place by the top and bottom of the device.
-
-
-
Remove the cover over the A/V ports on the front of the device.
-
-
-
Remove the board from the plastic enclosure and put the board into the replacement enclosure.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2947821:0crwdne2947821:0
crwdns2947823:0crwdne2947823:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-5, Sullivan Fall 2015 crwdns2935289:0USF Tampa, Team 1-5, Sullivan Fall 2015crwdne2935289:0
USFT-SULLIVAN-F15S1G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947410:01crwdne2947410:0
cause mine get’s hot and it’s slow as !&&*
