crwdns2915892:0crwdne2915892:0
In this guide, we will show you how to replace the microphone in a Ring Stick Up Cam. You will need a Phillips #00 screwdriver and a plastic opening tool.
crwdns2942213:0crwdne2942213:0
-
-
Remove the six 6mm Phillips #00 screws from the back of the device.
-
-
-
Pry off the aluminum plate using a plastic opening tool.
-
-
-
Remove the two 6mm Phillips #00 screws that were under the aluminum plate.
-
-
-
Pry off the back cover using a plastic opening tool.
-
-
-
Disconnect the battery power leads using a plastic opening tool.
-
-
-
Use a plastic opening tool to loosen the adhesive holding the battery in place and remove the battery by hand.
-
-
-
-
Remove the three silver 6mm Phillips #00 screws holding the motherboard in the device.
-
-
-
Disconnect the ribbon connector shown in the photo.
-
-
-
Remove the motherboard from the device by hand.
-
-
-
Remove the two black 5mm Phillips #00 screws holding the camera board into the device.
-
Remove the single silver 10mm Phillips #00 screw holding the camera board into the device.
-
-
-
Remove the three plastic spacers shown in the photo by hand.
-
-
-
Carefully disconnect the camera board from the daughterboard by sliding a plastic opening tool between the camera board and the daughterboard.
-
-
-
Lift the camera board out of the housing using your hand.
-
-
-
Remove the six silver 4.5mm Phillips #00 screws holding the daughterboard into the device.
-
-
-
Use a plastic opening tool to carefully pry the microphone from the housing.
-
-
-
Use your hands to remove the daughterboard containing the microphone from the housing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UC Davis, Team S18-G3, Lore Winter 2019 crwdns2935289:0UC Davis, Team S18-G3, Lore Winter 2019crwdne2935289:0
UCD-LORE-W19S18G3
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
