crwdns2915892:0crwdne2915892:0
If you are having trouble with the motion-activated lights and you would like to replace them, follow the 4 steps that are provided. It will take approximately 15-35 minutes.
crwdns2942213:0crwdne2942213:0
-
-
Remove the top plastic pad by peeling it off with a metal spudger.
-
-
-
-
Remove the 7 PH00 screws around the four corners with PH00 of the lid.
-
-
-
Use the metal spudger set to break the glue lining and the motion sensor will pop out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team S2-G1, Munoz Winter 2019 crwdns2935289:0Eastern Washington University, Team S2-G1, Munoz Winter 2019crwdne2935289:0
EWU-MUNOZ-W19S2G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:06crwdne2935297:0
crwdns2944067:02crwdne2944067:0
this showed nothing about replacing the light bulb
This is not a complete how to. The directions stop in the middle and don't show the replacement of the LEDs. Also no parts link for the replacement LED strips
