crwdns2915892:0crwdne2915892:0
The trigger mechanism can jam or become less responsive overtime. This is due to over use.
crwdns2942213:0crwdne2942213:0
-
-
Remove the seven 2.5 mm screws on the top of the sander using the Torx T15 screwdriver.
-
-
-
Remove the top of the sander and put to the side.
-
-
-
Use the screwdriver to unscrew the two #6-19 X 5/8 in screws holding down the outlet cord.
-
-
-
-
Remove the outer plastic piece holding down the white and black wires.
-
-
-
Unplug the two connecting pieces that hold wires.
-
-
-
Using the screwdrivers, unscrew the four #6-19 X 5/8 in screws on rectangular block.
-
-
-
Remove the black and white wires by pulling out.
-
-
-
Put the screwdriver in the holes to release remaining two wires.
-
-
-
Remove the two remaining wires from switch, leaving the switch freed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0