crwdns2915892:0crwdne2915892:0
This guide is to help users replace their faulty switch for the Ridgid GEN5X R8642 saw. For this guide you will need: a soldering iron, a spudger, a T20 Torx Screwdriver, a J1 size Phillips head screwdriver, and a replacement switch for Ridgid GEN5X R8642, and a good attitude.
crwdns2942213:0crwdne2942213:0
-
-
Remove the plastic tab holding the handle cover in place by prying upward with the spudger until the tab pops off.
-
-
-
Remove the handle cover by pulling it towards the front of the saw.
-
-
-
Use a T20 Torx screwdriver to remove the nine M4 X 16mm screws from the plastic housing.
-
-
-
-
Use a JIS #1 screwdriver to remove the two M4 x 25mm screws on both sides of the metal housing.
-
-
-
Remove one half of the plastic housing using a spudger so that the internal system is exposed.
-
-
-
Remove the plastic wire covers to the red and black connections on the switch assembly.
-
-
-
Remove the soldered connection from the switch assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Western Carolina University, Team S1-G3, Virtue Spring 2019 crwdns2935289:0Western Carolina University, Team S1-G3, Virtue Spring 2019crwdne2935289:0
WCU-VIRTUE-S19S1G3
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
