crwdns2915892:0crwdne2915892:0
This process involves removing the back cover, the front cover, and the zoom mechanism of the camera. After, the lens cover can be removed from the front cover.
crwdns2942213:0crwdne2942213:0
-
-
Use the screwdriver to unscrew the indicated screws from the left, right, bottom, and back sides of the camera.
-
-
-
Loosen the back cover from both the left and the right sides of the camera. Take off the back cover.
-
-
-
Open the film compartment.
-
Press your finger on top of the grey latch on the left side of the camera.
-
-
-
-
Use a thin object like a toothpick or a small screwdriver to push down on the metal pin holding the film compartment door in place.
-
Use your fingers to completely remove the metal pin.
-
Remove the film compartment door.
-
-
-
Use a thin shaft screwdriver and unscrew the two indicated screws within the film compartment.
-
-
-
Loosen the front cover from the left and right sides of the camera.
-
Take off the front cover.
-
-
-
The lens cover is only attached to the front cover of the camera. Set the rest of the camera aside.
-
In order to reach the lens cover, the zoom mechanism must be removed.
-
Unscrew three screws from the front cover that hold the zoom mechanism in place.
-
Remove the zoom mechanism.
-
-
-
Unscrew the five screws that hold the lens cover plate and metal brace in place.
-
Remove metal brace.
-
Remove lens cover plate.
-
-
-
To remove lens cover, push the lens cover from the outside of the front cover towards the inside of the front cover.
-
Remove the lens cover.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 6-21, Amido Spring 2012 crwdns2935289:0Cal Poly, Team 6-21, Amido Spring 2012crwdne2935289:0
CPSU-AMIDO-S12S6G21
crwdns2931471:04crwdne2931471:0
crwdns2935297:018crwdne2935297:0
