crwdns2915892:0crwdne2915892:0
When pulling this hair dryer's housing apart, the pink button controls will fall out. Their orientation when replacing them upon reassembly will be self explanatory because they only fit in one way, so don't be alarmed. Also, when desoldering the fan/motor assembly be sure to direct the force of the point of the soldering iron in a way as it will not slip and stab your support hand. If you do not know how to solder here is a useful link: How To Solder and Desolder Connections
crwdns2942213:0crwdne2942213:0
-
-
Using a Phillips #3 screwdriver, remove the single 25 mm Phillips head screw in the handle by turning it counterclockwise.
-
-
-
Using a medium flathead screwdriver or better yet iFixit plastic opening tools, gently pry apart the handle from the power cord.
-
-
-
-
After pulling apart the housing, all internals will be free to remove.
-
-
-
The fan/motor assembly is connected to the heating element assembly at two points need to be desoldered. After pulling the attached wires through the holes the fan/motor assembly will be free from the heating element assembly. Congratulations you have now completely removed the fan/motor assembly from this hair dryer!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S2-G2, Wilson Summer 2018 crwdns2935289:0IUPUI, Team S2-G2, Wilson Summer 2018crwdne2935289:0
IUPUI-WILSON-SU18S2G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:02crwdne2935297:0
