crwdns2915892:0crwdne2915892:0
If your controller(s) malfunction, you can replace the circuit boards. You only need a Phillips #1 screwdriver.
crwdns2942213:0crwdne2942213:0
-
-
-
With the controller on its face, remove the five 6 mm Phillips #1 screws.
-
After removing the screws, carefully lift the controller casing .
crwdns2952109:0crwdne2952109:0
-
-
-
-
Pinch the top and bottom of the shoulder buttons and lift them out.
-
Below each shoulder button, there are small elastic pads. To remove them, pinch the pads and slide them out.
-
-
-
Carefully lift the circuit board from the controller case.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935287:0crwdne2935287:0
USF Tampa, Team S4-G4, Eyestone Fall 2017 crwdns2935289:0USF Tampa, Team S4-G4, Eyestone Fall 2017crwdne2935289:0
USFT-EYESTONE-F17S4G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:055crwdne2935297:0
