crwdns2915892:0crwdne2915892:0
If the main board for your Respironics REMstar Plus M Series fails, follow this guide for instructions on how to replace it.
crwdns2942213:0crwdne2942213:0
-
-
Place the device face down.
-
Use a T15 Torx screwdriver to remove the six screws in the base plate.
-
Lift the base plate off of the device.
-
-
-
Flip the circuit board over to the right.
-
Gently pull the ribbon cable outward to disconnect it from the circuit board.
-
-
-
Disconnect the red 3-wire plug at the top left of the board and the white 4-wire plug at the bottom left.
-
Remove the circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
The Citadel Military College of South Carolina, Team S3-G22, Eggleston Fall 2020 crwdns2935289:0The Citadel Military College of South Carolina, Team S3-G22, Eggleston Fall 2020crwdne2935289:0
CMCSC-EGGLESTON-F20S3G22
crwdns2931471:02crwdne2931471:0
crwdns2935297:03crwdne2935297:0
crwdns2947412:02crwdne2947412:0
My unit stops working in the middle of the night, then beeps, & blue light flashes. Will replacing this board fix this, and where can I get one?
Where to find a power supply circuit board for my Remstar plus m series which just blinks blue lights. dledes@shaw.ca
