crwdns2915892:0crwdne2915892:0
The PODZ port is located on the back face of the Ion Air Pro. This port allows the WI-Fi PODZ Pack accessory to be installed.
crwdns2942213:0crwdne2942213:0
-
-
Remove the 6 screws securing the lens cover bezel using a #00 Phillips screwdriver. This will allow you to remove the bezel and lens cover.
-
-
-
Remove the metal camera body cover by sliding it toward the lens end of the camera.
-
-
-
Remove 2 screws on the bottom of the camera body using a #00 Phillips screwdriver.
-
-
-
-
Remove the 3 screws that secure the camera to the body using a #00 Phillips screwdriver.
-
-
-
Use a plastic pry tool to remove the plastic ring covering the rear screws.
-
-
-
Remove the 8 screws around the perimeter of the back cover.
-
Remove the 2 screws in the PODZ port.
-
-
-
Slide PODZ port out of the camera body.
-
Disconnect ribbon cable from the back of the PODZ port.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
UW Stout, Team S6-G2, Ogden Fall 2018 crwdns2935289:0UW Stout, Team S6-G2, Ogden Fall 2018crwdne2935289:0
UWSTOUT-OGDEN-F18S6G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
crwdns2917034:0crwdne2917034:0
How do you reconnect the ribbon cable to the back of the PODZ port when you reassemble?
