crwdns2915892:0crwdne2915892:0
This guide will show you how to replace the speaker from your Atari Lynx. Before beginning, it is a must to know how to solder and desolder. In order to find out how to do these processes there will be a link in the the following steps. Aside from soldering, most steps should be easy to follow and simple.
crwdns2942213:0crwdne2942213:0
-
-
Before disassembling your Atari Lynx, be sure the device is powered off.
-
Remove any game in the console by opening the right latch and sliding the game to the right.
-
-
-
Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
-
Pinch the rear panel with your fingers and lift away from the Atari.
-
-
-
-
Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.
-
-
-
Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.
-
-
-
Remove the logic board from the console.
-
Flip the logic board so the screen is facing down.
-
-
-
Now you will need to desolder both of the wires connected to the speaker.
-
If you are having trouble desoldering, click here.
-
Finally solder the new speaker back on and follow the previous steps in reverse order.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 1-42, Maness Winter 2014 crwdns2935289:0Cal Poly, Team 1-42, Maness Winter 2014crwdne2935289:0
CPSU-MANESS-W14S1G42
crwdns2931471:05crwdne2931471:0
crwdns2935297:016crwdne2935297:0
crwdns2947412:02crwdne2947412:0
Does anyone know the screw sizes for the lynx 2 console please
What are the specs on the speaker? Size? Wattage?
