crwdns2915892:0crwdne2915892:0
This repair guide will show you how to replace the shutter in your Polaroid camera. However, you should be careful with your Polaroid, as the plastic is very fragile.
crwdns2942213:0crwdne2942213:0
-
-
Open the flash/ lens compartment of the Polaroid camera to a 30 degree angle with the horizontal.
-
-
-
Separate the flash section of the camera from the main body by unhooking the sides.
-
-
-
Open the battery/ cartridge compartment fully.
-
-
-
Insert spudger in between face of camera and sides where the four tabs are located.
-
-
-
Once tabs are released, pull face of camera straight out.
-
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Carefully use tweezers to remove the spring from the hooks.
-
-
-
Use the spudger to release the latch for the shutter mechanism.
-
Rotate the shutter mechanism clockwise until it stops.
-
-
-
Release the two tabs that hold lens plate in position.
-
-
-
Remove the lens plate by pulling down, then away from the camera.
-
-
-
Remove the shutter mechanism from the camera.
-
Remove black latch piece from the camera.
-
Remove shutter plates from the camera.
-
-
-
To replace the shutter pieces in the camera, first make sure they are in the proper order.
-
The shutter piece at the bottom of the first picture belongs on the bottom.
-
The shutter piece in the middle of the first picture goes in the middle (second picture).
-
The shutter piece at the top of the first picture goes on top (third picture).
-
-
-
By looking at the first picture, line up the long, skinny slots on the three shutter pieces.
-
In the second picture, notice the pin inside the circle.
-
Line up the slots in the shutters with the pin inside the camera as shown in the third picture.
-
-
-
Put black plastic piece back into camera, making sure to slide tab into slot (rectangle) and onto the pin (circle).
-
Final assembly for this step should look like the third picture.
-
-
-
First, you must align the tab (circled) with the slot (rectangle).
-
-
-
Align teal and orange circled tabs from the first picture with the respective teal and orange holes in the shutter pieces.
-
After the shutter mechanism is placed into the camera, make sure all three shutter pieces are attached correctly.
-
To finish putting the Polaroid back together, follow steps 9 through 1 in reverse.
-
crwdns2935221:0crwdne2935221:0
crwdns2935229:07crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 16-31, Maness Winter 2010 crwdns2935289:0Cal Poly, Team 16-31, Maness Winter 2010crwdne2935289:0
CPSU-MANESS-W10S16G31
crwdns2931471:04crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947410:01crwdne2947410:0
I'm pretty sure every type 600 polaroid camera is built the same so this should work with other 600 cameras. I followed this guide for my polaroid 640 land camera and it was exactly the same.
