crwdns2915892:0crwdne2915892:0
Need to get inside the amp? Remove the back panel!
crwdns2942213:0crwdne2942213:0
-
-
Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame.
-
-
-
-
Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.
-
-
-
Once the top is separated, use your hand to remove the back panel from the unit.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 24-30, Regan Fall 2012 crwdns2935289:0Cal Poly, Team 24-30, Regan Fall 2012crwdne2935289:0
CPSU-REGAN-F12S24G30
crwdns2931471:05crwdne2931471:0
crwdns2935297:07crwdne2935297:0
crwdns2947412:02crwdne2947412:0
I need to know where to find a used circuit board for my Fender Frontman 15G. A circuit board from a Fender Frontman 15R will also work. Please help me.
The way to get the electronics out is by removing the front panel, because removing them through the back is not possible because of the reverb unit. In case you need to disassemble a Fender frontman 15R, have a look at https://www.youtube.com/watch?v=ioQnwjgv...
