crwdns2915892:0crwdne2915892:0
If the mouse scroll wheel will not respond as it should, the scroll wheel encoder might need replacement. Reasons for the scroll wheel encoder to be repaired is because it is either out of date and needs a replacement or you need to reinstall Synapse 3. This guide will list all required steps to properly replace the LK-E5 Optical Encoder from the Razer Naga Trinity.
crwdns2942213:0crwdne2942213:0
-
-
Remove the interchangeable side plate.
-
-
-
Remove the mouse's feet using the opening pick.
Be aware that it’s possible to peel the feet from the glue layer.
-
-
-
Remove the four 6mm screws by using a JIS #1 screwdriver.
-
-
-
Separate the top mouse housing from the bottom mouse housing using the opening pick.
-
-
-
Unlock the ribbon connector that is held down by the main board clips using the spudger's pointed end.
-
-
-
-
Remove the side housing using the opening pick.
-
-
-
Remove the top housing LED 3-Pin connector that is near the main board.
-
-
-
Remove one 4mm black Phillips #000 screw from the left side of the mouse holding the scroll wheel LED controller board.
-
Then pull the LED controller board upwards and out.
-
-
crwdns2935267:0crwdne2935267:0Halberd Spudger$2.99
-
Pry and remove the scroll wheel feedback bar from its hold-down clips using the hook end of a halberd spudger.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$3.99
-
Remove the scroll wheel feedback bar from the scroll wheel by holding down the spring and using angled tweezers to remove it from its placement.
-
-
-
Remove the scroll wheel optical encoder 3-pin connector from the main board by wiggling the connector upwards.
-
-
-
Using the opening tool, pry the black bracket holding the scroll wheel in place backwards until the scroll wheel housing pops out.
You don't have to remove that part, if you're careful you can leave the mouse wheel attatched to the mainboard because it's pretty fiddly to get the feather inside again.
-
-
-
Remove the scroll wheel from the scroll wheel housing using the opening tool.
-
-
-
Remove the scroll wheel optical encoder from the scroll wheel.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team S6-G2, Salas Fall 2019 crwdns2935289:0Embry-Riddle Aeronautical University, Team S6-G2, Salas Fall 2019crwdne2935289:0
ERAU-SALAS-F19S6G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:011crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Where can we buy a replacement from?
