crwdns2915892:0crwdne2915892:0
If your drill does not turn on with a fully charged battery, the motor of your drill might be damaged. This guide will provide guidance to the process of replacing a defective motor in a RIDGID R860052.
crwdns2942213:0crwdne2942213:0
-
-
Use a T10 Torx screwdriver to remove the ten screws on the information label side of the drill.
-
-
-
Lift off and remove the cover with the informational label.
-
-
-
-
Remove the switch assembly, chuck, and motor from all drill covers.
-
-
-
Twist the chuck and motor in the opposite direction and gently pull them apart.
-
-
-
Desolder the black and red wires from the motor.
-
Replace motor and resolder the black and red wires back onto the motor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.