crwdns2915892:0crwdne2915892:0
If your RIDGID Belt Sander R2740 is making abnormal sounds the cause could be from a worn or damaged ball bearing. This guide will teach you how to replace the ball bearing. For this guide, you will need a screwdriver with a T20 head and a hammer.
crwdns2942213:0crwdne2942213:0
-
-
Orient the belt sander so that the AirGuard Technology logo is facing you.
-
Remove the nine 19mm, two 51mm and one 32 mm screws that hold the cover into place.
-
Remove the cover from the belt sander.
-
-
-
-
Remove the assembly armature from the belt sander.
-
-
-
Use a hammer to pry the ball bearing from the assembly armature.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0