crwdns2915892:0crwdne2915892:0
This replacement guide will teach you how to replace a worn speaker. This will ensure the device has quality sound. If the speaker has not fixed the issue there may be an electrical shortage in the device.
crwdns2942213:0crwdne2942213:0
-
-
Push down on the clip to release pressure. The pull off the plastic cover.
-
-
-
Remove the 9-volt battery from the battery terminal.
-
-
-
Take out the six screws located on the back of the device.
-
The red screws are 10 mm Phillip's #1. The orange screws are 13 mm Phillips #1.
-
Three screws are located on the back panel. One is located inside the battery carriage.
-
Two screws are located on the on the back panel on the bottom left and right side.
-
-
-
-
Remove the 10 mm Phillip's #1 screw.
-
Then remove the metal reinforcement.
-
-
-
Using flathead screwdriver undo the release tabs.
-
-
-
Pry the release tabs with a spudger.
-
Start with back of the device on the topside.
-
-
-
Pry open both tabs to remove the topside of the clock.
-
-
-
Remove the two 10mm Phillip's #1 screws. Also remove the two reinforcements holding the speaker in place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 10-5, Brown Fall 2014 crwdns2935289:0USF Tampa, Team 10-5, Brown Fall 2014crwdne2935289:0
USFT-BROWN-F14S10G5
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
