crwdns2915892:0crwdne2915892:0
In order to get to the speakers, the battery, back panel, and logic board need to be disassembled first.
crwdns2942213:0crwdne2942213:0
-
-
Locate your device.
-
Flip device onto its back.
-
-
-
Locate the battery and remove it.
-
If you wish to replace the battery you can do so here.
-
-
-
Use the Phillips PH1 screwdriver to unscrew the five 4x2.5mm screws that hold the back cover.
-
-
-
-
Start by disconnecting the cables attached to the motherboard
-
use the spudger to lift the connectors vertically off. They should pop off with relative ease
-
The last connector has a yellow tab. Pull up on the tab until the small metal catch lifts up. Then pull straight back to remove the connector from its socket.
-
-
-
Using the Phillips PH1, remove all 6 of the 3x2.5mm screws (circled in red) holding the motherboard in place.
-
-
-
Using the spudger lift the motherboard out of the tablet frame.
-
-
-
Locate the two speakers in each of the bottom corners (left and right).
-
-
-
Use the Phillips PH1 screwdriver to remove the 3x2.5mm screw on the right speaker.
-
-
-
Use the spudger to disconnect the speakers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team S2-G6, Thompson Fall 2017 crwdns2935289:0University of North Texas, Team S2-G6, Thompson Fall 2017crwdne2935289:0
UNT-THOMPSON-F17S2G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
