crwdns2915892:0crwdne2915892:0
The Pyle Astro's power button is a simple push button switch that is soldered onto the main PCB. Use this guide to replace your tablet's power button.
crwdns2942213:0crwdne2942213:0
-
-
Using the plastic opening tool, work your way along the edge of the tablet.
-
Once all clips are released, gently open and separate the front display assembly and the rear plastic panel.
-
Place the front display assembly facing front side down to expose the inside.
-
-
-
Remove the three 4 mm JIS #0 screws to release the PCB board.
-
-
-
-
Flip the PCB board upside down to expose the solder joints for the power button.
-
Gently de-solder the four solder joints of the push button switch (power button).
-
-
-
Install the new push button switch and solder all the connections back into place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S3-G6, Harley Spring 2018 crwdns2935289:0IUPUI, Team S3-G6, Harley Spring 2018crwdne2935289:0
IUPUI-HARLEY-S18S3G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
