crwdns2942213:0crwdne2942213:0
-
-
Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
-
-
-
Remove the 1.2 cm hex T9 screws and gently open up the device.
-
-
-
Flip the top bar over and using a #00 phillips head screwdriver, remove the five 7mm screws holding the bar together.
-
-
-
-
Carefully pry off the plastic panel, revealing the motherboard.
-
-
-
Remove the two 7mm screws holding the motherboard in place with a phillips head screwdriver size #00.
-
-
-
To release the motherboard from its plastic housing, first pull the plastic light covers up and away from the device.
-
-
-
Heat the solder on the underside of the affected light to remove and replace it using tweezers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Appalachian State University, Team S2-G6, Menagarishvili Fall 2018 crwdns2935289:0Appalachian State University, Team S2-G6, Menagarishvili Fall 2018crwdne2935289:0
APSU-MENAGARISHVILI-F18S2G6
crwdns2931471:03crwdne2931471:0
crwdns2935297:04crwdne2935297:0
