crwdns2942213:0crwdne2942213:0
-
-
Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
-
-
-
Remove the 1.2 cm hex T9 screws and gently open up the device.
-
-
-
-
Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.
-
-
-
Use a plastic spudger to push the black sliding cable connector away from the white bracket.
-
-
-
Gently remove the ribbon cable from the connector.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.