crwdns2915892:0crwdne2915892:0
This guide shows you how to replace the motors on your drone. Soldering is a skill required for this task. Replacement motors can be found on the manufacturer's website.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four blades by pulling them off of the motors.
-
-
-
Remove the blade guards by pushing the guards downward towards the padded feet.
-
-
-
-
Remove the four 4.5mm Phillips #0 screws from the back panel.
-
-
-
Use the flat end of a spudger to pry apart the the two pieces.
-
Lift the back panel up to separate it from the front panel.
-
-
-
Pull the four motors out of the case.
-
-
-
Use a soldering iron to desolder the motors from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.