Protocol Dronium Two Blade Guard Replacement
crwdns2959932:0crwdnd2959932:0Edwin Brietzcrwdnd2959932:0crwdnd2959932:0crwdne2959932:0
crwdns2959936:0Kho 23, 2017crwdne2959936:0
crwdns2869540:0crwdne2869540:0: 556
crwdns2959988:0crwdne2959988:0
- crwdns2959990:0crwdne2959990:0
- 2
- crwdns2959992:0crwdne2959992:0
- 14
- crwdns2959994:0crwdne2959994:0
- 64
- crwdns2959996:0crwdne2959996:0
- 556
crwdns2955950:0crwdne2955950:0: 0
crwdns2959998:0crwdne2959998:0
crwdns2960000:0crwdne2960000:0crwdns2959984:0crwdne2959984:0: 2 3
crwdns2959974:02crwdne2959974:0
crwdns2959970:03crwdne2959970:0
crwdns2959986:0crwdne2959986:0: 0 1
crwdns2959958:0crwdne2959958:0
crwdns2959976:01crwdne2959976:0
crwdns2915892:0crwdne2915892:0
crwdns2959928:0crwdne2959928:0 ↓This guide shows how to remove the blade guard on the Protocol Dronium Two. The only tool you will need is the #0 Phillips screwdriver. The screwdriver is also included in the box of your drone. Perform this repair in a clean and well lit area so that you don't lose the screw.
crwdns2959930:0crwdne2959930:0
-
-
-
Turn the drone off by moving the selector switch to the left.
crwdns2952109:0crwdne2952109:0
-
-
-
-
Using your screwdriver, remove the 8.36mm Phillips screw.
-
-
-
While holding the drone with one hand, gently lift the blade guard straight up and remove it.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2935287:0crwdne2935287:0
Arkansas State University, Team 1-2, Chamberlain Spring 2017 crwdns2935289:0Arkansas State University, Team 1-2, Chamberlain Spring 2017crwdne2935289:0
ARSU-CHAMBERLAIN-S17S1G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:060crwdne2935297:0
