crwdns2915892:0crwdne2915892:0
This guide will walk you through the simple steps to replace the landing gears to help your drone land and fly properly.
crwdns2942213:0crwdne2942213:0
-
-
Remove the eight 5.2mm screws located on the drone base using a Phillips 00 screwdriver with a thin end.
-
-
-
Once all of the screws are off, lift off the top of the drone.
-
-
-
-
Remove the two 5.2mm screws holding the landing gear in place using a Phillips 00 screwdriver and an extension if needed.
-
-
-
Once the inside screws are removed, carefully pull off the one of the landing gear legs. Repeat this step for the other leg.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.