crwdns2915892:0crwdne2915892:0
This guide explains how to replace the Protocol Dronium III AP Camera.
crwdns2942213:0crwdne2942213:0
-
-
Press in and lift battery compartment cover.
-
-
-
Remove battery pack from body of drone.
-
-
-
Disconnect white connectors between the battery pack and drone.
-
-
-
Remove the eight (8) 5mm screws attaching the motor arms to the body using a JIS #00 screwdriver.
-
-
-
-
Remove the six (6) 5mm screws attaching the Body Cover to the Body of the drone using a JIS #00 screwdriver.
-
Remove the Body Cover.
-
-
-
Remove the two (2) 5mm screws attaching the Motherboard to the body of the drone using a JIS #00 screwdriver.
-
Lift the Motherboard off the mounting position.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Remove the tape covering the camera with the tweezers.
-
-
-
Remove the plastic holding the ribbon cable connector with the tweezers.
-
-
-
Move the ribbon cable out of the way with the Spuger.
-
-
-
Remove the camera by gently prying it out of the bracket with the spudger.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.