crwdns2942213:0crwdne2942213:0
-
-
Remove the back cover of the machine.
-
Remove the heater pin from the back side of machine.
-
-
-
Remove the groove screw from the downside of nozzle.
-
Preheat the machine
-
After getting preheated, pull slowly the wires of the heater back. and remove the nozzle out.
-
-
-
-
Reset the machine.
-
After the temperature get down full, preheat the machine
-
After 30 second check the heater is getting heated or not by slowing touch and removing your hand fastly
-
If it is not getting heating, you has to change the heater.
-
-
-
First remove the heater from the wire by desoldering.
-
Take the multimeter and put it in continuity check mode and connect the two end of the wire in end of two probe of multimeter.
-
Check whether the beep sound is coming. If the beep sound come, it means the wire is good , else you has to change the wires. Same way check the other wire also.
-
-
-
After checking these, you has to reconnect the heater in the same way you have removed before.
-
-
-
Preheat the machine
-
Go back to main menu
-
check the nozzle temperature is increasing or not.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
