crwdns2942213:0crwdne2942213:0
-
-
Use the flat end of a spudger to pry the sound card ribbon cable connector up off the logic board.
-
Move the sound card ribbon cable away from the face of the hard drive.
-
-
-
-
Use the flat end of a spudger to pry the hard drive ribbon cable connector up off the logic board.
-
-
-
Remove the following four screws:
-
Three 11.1 mm T8 Torx.
-
One 3.9 mm T8 Torx.
-
Lift the hard drive out of the lower case.
-
crwdns2935219:0crwdne2935219:0
To reassemble your device, follow these instructions in reverse order.
crwdns2915888:0crwdne2915888:0
To reassemble your device, follow these instructions in reverse order.