crwdns2915892:0crwdne2915892:0
This guide includes instructions on how to remove and replace the D-Pad button from the PowerA Spectra controller.
The D-Pad is a plus-symbol-shaped button that allows for four different inputs. The button can usually fail to work because of dirt buildup in the button itself.
Make sure to disconnect the controller from any electrical sources before beginning.
crwdns2942213:0crwdne2942213:0
-
-
Flip the controller over so the backplate is facing up.
-
-
-
Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.
-
-
-
Hold the front case in one hand and pull the rear case off.
-
-
-
-
Use a Phillips screwdriver to remove the two 7.8 mm screws securing the motherboard to the chassis.
-
-
-
Gently take the motherboard off of the front plate.
-
-
-
Use Phillips screwdriver to remove the four 7.8 mm screws that secure the D-pad.
-
To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.
crwdns2915084:0crwdne2915084:0
University of North Texas, Team 2-1, Coppersmith Fall 2024 crwdns2935289:0University of North Texas, Team 2-1, Coppersmith Fall 2024crwdne2935289:0
UNT-COPPERSMITH-F24S2G1
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
