crwdns2915892:0crwdne2915892:0
Removing the hard drive of the Power Mac G4 Quicksilver for replacement.
crwdns2942213:0crwdne2942213:0
-
-
The handle to open your computer is located on top of the right side panel.
-
-
-
Grab the circular handle and pull outward.
-
-
-
Your computer is now open and ready for repair.
-
-
-
The hard drive is located in the rear right corner of the case.
-
-
-
-
Unplug the IDE ribbon cable. This is the wide flat grey cable.
-
-
-
Remove the screw holding down the hard drive enclosure.
-
-
-
Lift the hard drive enclosure straight up and out.
-
-
-
Remove the four screws holding the hard drive to the enclosure.
-
-
-
Your hard drive is now free from the enclosure and is ready to be replaced.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:08crwdne2935229:0